Smart Home Pulse may earn a commission if you buy through links on this page. It doesn’t change what we recommend. See our affiliate disclosure.
Quick answer: Ontario law requires a working smoke alarm on every storey and outside all sleeping areas. If your home has a fuel-burning appliance, a fireplace or an attached garage, you also need CO alarms next to each sleeping area. Since January 1, 2026, you need a CO alarm on every storey too, even floors with no bedrooms.
Why this matters in Canada
Ontario homes run on furnaces, gas water heaters, wood stoves and fireplaces for months. In winter the windows stay shut. That is when a CO leak does the most harm, and you can’t see or smell the gas.
The rules changed this year. The Ontario Office of the Fire Marshal’s fact sheet for existing homes says the CO rules apply to homes with any of these:
- A fuel-burning appliance, such as a furnace, water heater or stove that uses natural gas, propane, oil or wood.
- A fireplace.
- An attached garage.
- Heating air that comes from a fuel-burning appliance outside the home, such as one in a utility shed (new as of January 1, 2026).
The fact sheet lists detached and semi-detached houses, townhouses and cottages as common examples. Ontario’s CO safety page, updated December 30, 2025, says apartments and condo units must also have a CO alarm on every storey of the unit.
Who is responsible? In an owner-occupied home, the homeowner. In a rental, the landlord. Ontario’s fire safety page says that breaking the smoke alarm rules can bring a $360 ticket, or a fine of up to $50,000 for individuals and $100,000 for corporations.
Smoke alarms and CO alarms have different shelf lives. Ontario says to replace smoke alarms every 10 years, following the manufacturer’s instructions. For CO alarms, Ontario says to replace them according to the manufacturer’s instructions. It doesn’t set a fixed number of years.
Comparison table
This post is about the rules, not Wi-Fi features. The table only lists what we could confirm on manufacturer pages for each model.
| Model | Alarm type | Power | Sensors | Life noted on page |
|---|---|---|---|---|
| Kidde P3010CU | Smoke and CO combo, voice warning | Sealed battery | Photoelectric (smoke), electrochemical (CO) | 10-year battery |
| X-Sense SC01 | Smoke and CO combo, with display | Sealed lithium battery | Photoelectric (smoke), electrochemical (CO) | 10-year battery |
| First Alert CO400A | CO only | Battery-operated | Electrochemical (CO) | Sensor lasts up to five years |
Our picks
Best for covering smoke and CO on every floor: Kidde P3010CU
Kidde’s page describes this as a 10-year sealed-battery combination alarm. It uses a photoelectric sensor for smoke and an electrochemical sensor for CO. It also has a voice warning system that announces the hazard type, plus a Smart Hush feature.
A combo unit is a simple way to meet both rules on a floor with no bedrooms. One thing to check before you buy: Kidde’s page says this model is to be replaced with a newer one, so confirm stock.
Best for a no-battery-swap combo with a display: X-Sense SC01
X-Sense describes the SC01 as a standalone smoke and CO alarm with a sealed 10-year lithium battery that can’t be replaced. When the battery runs low, you replace the whole unit. It has an LCD that shows CO readings and battery status.
Your fire department enforces the Fire Code. Ontario says to look for a CSA, ULC or Intertek (ETL) mark on any CO alarm you buy. Check the box for one of those marks before you buy.
Best for adding a CO alarm to a floor that only needs CO: First Alert CO400A
First Alert Canada’s page for this alarm says it has an electrochemical sensor that lasts up to five years. It is battery-operated and has a low-battery light. It also has an end-of-life warning and a single test/silence button.
Ontario allows hardwired, battery-operated and plug-in CO alarms. A battery unit is easy to add to a basement or an upper landing without an electrician.
Practical tips
- Count your storeys first. Basements and finished attics count, even with no bedrooms. Every storey needs a CO alarm if your home has a fuel-burning appliance, a fireplace or an attached garage.
- Put smoke alarms on the ceiling. If you can’t, mount them high on a wall. Ontario says to keep them away from bathrooms, windows, ceiling fans and cooking appliances.
- Test every alarm monthly with the test button. Ontario also says to put in a new battery at least once a year, or as the manufacturer recommends.
- Write the install date on the alarm. Ontario says to replace smoke alarms every 10 years.
- Look for a CSA, ULC or Intertek (ETL) logo before you buy.
- Landlords: you are responsible for the CO alarms in a rental home. Don’t leave it to the tenant.
FAQ
Do I need a CO alarm if I have an electric furnace and no fireplace?
The Ontario fact sheet ties the requirement to a fuel-burning appliance, a fireplace or an attached garage. If none of those apply to your home, the rule may not apply. Ask your local fire department to confirm, since they enforce the Fire Code.
Can I use a combined smoke and CO alarm?
Yes. The Ontario fact sheet notes that many devices on the market combine both in one unit. Make sure the model is certified and suited to where you install it.
Who enforces these rules and who do I ask?
Your local fire department enforces the Fire Code in your area. Ontario’s fact sheet tells you to contact them with questions about your home.
